What Is A House Circuit Panel ?
Sunday, February 28th, 2010Wise homeowners feel it their duty to handle the electrical irregularities of their home. However, when it comes to the wiring of any electrical segment then they prefer to maintain a distance. This is due to the misconception that the wiring jobs are too complicating and dangerous for the novices. However, the truth is far from the misconception.
Hence, following few tips can save the day for your electrical segment. A house circuit panel is one such electrical segment that is normally handled by the experts. However, it is just a misconception that the beginners cannot install a hose circuit panel.
Walk down to the main breaker box and switch of all the breaker switches one by one. Alternatively, you can undo the electric fuse by pulling out its cap. If you don’t know the location of your breaker box or the electric fuse then visit your basement or the sidewalk. Carry a voltage tester to test the electricity-deprived state of the concerned electric circuit.
Initialize the task of wiring by undoing the knockout holes on the side of the panel. The number of holes opened must be in accordance with the number of connections to be made. Hence, it is very important to know the exact number before commencing the wiring operation. Use regular hose clamps to keep the holes in place. Often, the users end up opening more knockouts than required. Such a practice must be avoided in the first place.
Allow the required length of cable to be pushed into the panel box. Next, connect the ground wire to the terminal located on the side of the grounding bus bar.
Move over to the wiring of the white wire and the black wire further. While the white wire represents the neutral terminal, the black wire corresponds to the hot (line) wire. Take off some insulation from the tips of the white wire and the black wire. Handle the cutters and strippers properly as improper application may lead to bruises or nicks. Attach the white wire to the terminal of the neutral bus bar.
Besides the neutral bus bar and the ground bus bar, there are a number of single pole circuit breakers. Use one of them to encapsulate the leading end of the black wire. With the help of a screwdriver, secure the screws in place.
Finish off the task by pushing one end of the new panel into a hook. The hook lies next to the bus bar. Sometimes the wire may not find an easy passage into the hook. Hence, keep pushing the wire until it accommodates in the panel.
Scott Rodgers is a fine expert who has been authoring on electricians contents for a long time now. His superb guidance has given motivation to a host of workers, ranging from Johnstown Electricians (Need one?click here!) to South Pasadena Electricians (Need one?click here!).

